Page 1 of 1
75hp Mercury
Posted: Fri Aug 11, 2006 8:48 pm
by jaybird17
My motor wont start at all, new gas, drove for about 1 hour in the rideau thismorningand then trailered it to the Ottawa and now wont start. Any suggestions? Any and all would be appreciated.
Thanks
won't start
Posted: Fri Aug 11, 2006 9:19 pm
by Haybay Larry
Jaybird,
I'm assuming it will crank over. Do you get a sprk at the plug? Try cranking the engine while you place a screwdriver -one end touching the engine block and the other very close to the sprkplug connection that you have removed from one plug. You should see a small spark.
You should also see if gas will squirt out of the gas connector that is connected to the motor when removed.
If you ar running a vented gas can, was the vent open?
You mentioned you drove for about 1 hour in the rideau and then trailered it. Did you mean you were boating on the rideau for an hour?
Try the ideas it will help you isolate the area of the problem....Larry
Posted: Fri Aug 11, 2006 9:32 pm
by jaybird17
Thanks Larry. I will do the spark test agqain. Yes the vent is open and yes I was boating on teh Rideau, actually fishing and then trailered it to the Ottawa to try some fishing there. Will try and get back to you. Thanks Man
Posted: Sat Aug 12, 2006 5:24 pm
by CNs
Did you check your kill switch???
I did this with my old 30 hp. I remove d the kill swicth lanyard when trailering so I wouldn't lose it. I forgot to put it back on
Spent 30 miinutes trying to start it. It was a manual start.
Posted: Sat Aug 12, 2006 8:27 pm
by Bear
normware wrote:Did you check your kill switch???
I did this with my old 30 hp. I remove d the kill swicth lanyard when trailering so I wouldn't lose it. I forgot to put it back on
Spent 30 miinutes trying to start it. It was a manual start.
Man that susks when that happens
Been there. done that, twice
